Bimota Forum

I forgot to tighten the screws on my Bimota YB6 seat back pad and one of them vibrated out somewhere along the road. They are not avaiable from my local fastener store. It is a 6mm countersunk screw w ...

Rex Wolfenden of T-Rex racing in Heidelberg Melbourne built a YB5 race bike and I read that he had moulds and replica race fairings made. You could try calling him on 03 9457 5411. He maybe able to po ...

Pressure regulator doesn’t seem to be a problem. From what I’ve read they’re pretty reliable. However just a tip be sure to tighten fuel pump and filter hose clamps FIRMLY. Don’t ask why I mention th ...

I can only dream of being able to claim to motocross a Bimota down our track Wink

The best I can do is about 40 kph with my right hand on the throttle and my left hand trying to stop the fairing ...

Had been concerned about the way the fairing vibrated on my YB6EI since I got it about 18 months ago. I live down a pot holed limestone road so it gets a bit of a work out. Recently removed the fairin ...

I put an or o-ring in mine and replaced a gasket i think, was years ago when it leaks as you say out the wires.

Mine has a brass pipe which is attached possibly by capillary action brazing to the c ...

Managed to get the pump out of the housing. Resorted to twisting with multi grips and in the end lots of lubricant. Mine was a Bosch 0580 463 999 which maybe used in other Bims is also used in the Duc ...

From what I can gather the weber pump part number pi-002 is replace by
Bosch 0580464993
Walbro FP604
FSE-syntec OTP020
This would probably apply to later fuel injected models as wel ...

Back on topic.
https://i.imgur.com/UupqdK7.jpg
Garage: Front row: Egli Honda 836 being rebuilt, MV Agusta F4 1000 312R cam cap bolt needing drilling out to adjust valve clearances.
Second row: Bimo ...

We used older military parachutes as Claude claimed they were safer at the time. Like 2Bims we jumped from 3000 ft with static lines.

Hi Arnie, yes I was professional skydiver, and rigger for over a decade. I was into 4-way relative work competition, and coaching. At the same time, I set up and operated the sales and service compa ...

Who: from the look of the material covering a lot of your bikes did you have a liking for jumping out of perfectly good aeroplanes at some time. Did you get your RS250 from your Timorese escapee mate. ...

I thought the alternator was bolted into the cover, maybe there's an issue with the Bimota frame that I'm not aware of (I know the engine from the ThunderCat
My YB6EI is fitted with the 1988 original ...

Removed clutch slave cylinder and front sprocket cover and was able to slip alternator out.

My YB6EI has stopped charging. The alternator rotor coil windings seem to be open circuit. I have purchased a replacement alternator on its way from eBay supposedly rebuilt in the states with rebuilt ...