| View previous topic :: View next topic |
| Author |
Message |
Pillingb
Joined: 28 Jun 2017
Posts: 11
Location: Cumbria
|
 Posted: Sun Jun 13, 2021 8:48 pm Post subject: YB9 velocity stack |
 |
|
Just started recommissioning an old YB9. I have discovered I only have three of the four velocity stacks and the FZR velocity stacks available on ebay are much taller.
Could I use the tall FZR stacks with out further carburetor adjustments? Or should I take them all off!
Needless to say I cannot see any of the stubby YB9 velocity stacks.
Any thoughts? Thanks in advance. |
|
| Back to top |
|
 |
phil-short
Joined: 30 Jul 2012
Posts: 197
Location: Dublin,Ireland
|
| Posted: Wed Jun 16, 2021 7:54 pm Post subject: |
|
|
| Don't know whether the price would be over the top but how about getting one 3d printed to match? |
|
| Back to top |
|
|
Pillingb
Joined: 28 Jun 2017
Posts: 11
Location: Cumbria
|
| Posted: Thu Jun 17, 2021 3:34 pm Post subject: |
|
|
That’s an interesting idea I hadn’t considered it. I think what I’ll do is change them all to the tall fzr stacks and see how it goes. I suspect it will make little difference but for a little more top end perhaps.
But, if this doesn’t produce a smooth running engine my brother is a cad engineer and I think he recently bought a 3D printer!
Good thinking Phil! Thanks for the prompt. |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
